1.使用機械手時，必須使用清潔、干燥的壓縮空氣。

When using a robotic arm, clean and dry compressed air must be used.

　　2.僅允許在身體狀態(tài)良好時啟用本設備。

2. This device is only allowed to be used when the body is in good condition.

　　3.使用前先檢查相應的承重螺栓是否松動。

3. Before use, check whether the corresponding load-bearing bolts are loose.

　　4.每次使用前，檢查設備有無磨損或損傷。在無法確保的情況下，不要使用已檢測出有磨損及損傷的系統(tǒng)。

4. Before each use, check the equipment for wear or damage. Do not use systems that have been detected for wear and damage in situations where safety cannot be guaranteed.

　　5.設備啟用前需打開各個壓縮空氣管路閥門，檢查氣源壓力是否滿足要求，壓縮空氣中不能含油和水分。

Before using the equipment, it is necessary to open the valves of each compressed air pipeline and check whether the air source pressure meets the requirements. The compressed air should not contain oil or moisture.

　　6.檢查過濾減壓閥的濾杯中是否有超過刻度標記的液體，及時排空，以防污染元器件。

6. Check if there is any liquid in the filter cup of the filter pressure reducing valve that exceeds the mark on the scale, and drain it in a timely manner to prevent contamination of the components.

以上就是有關 焊接機械手臂 的介紹，想了解更多的內(nèi)容請點擊：http://www.avsteel.cn 我們將會全心全意為您提供滿分服務，歡迎您的來電！

The above is an introduction to welding robotic arms. To learn more, please click: http://www.avsteel.cn We will wholeheartedly provide you with full score service. Welcome to call us!